Taurus V6-195 3.2L DOHC SHO (1994)
3.8L Engine
Removal
1. Drain engine cooling system by removing radiator cap and opening radiator drain cock located at lower rear corner of radiator inlet tank (8079).
Three revolutions are required to open radiator drain cock to full open position.
2. Remove radiator overflow hose from radiator coolant recovery reservoir and detach it from radiator.
On 3.OL / 3.2L SHO, disconnect tube from radiator and remove radiator coolant recovery reservoir. Refer to illustration.
3. Disconnect battery ground cable.
4. Remove two fan shroud upper retaining screws and lift fan shroud out of lower retaining clip.
5. Disconnect the radiator electric motor wire harness and remove radiator electric motor / fan blade / fan shroud assembly.
6. Loosen upper radiator hose and lower radiator hose clamps at radiator and remove hoses from radiator tank connectors.
7. Disconnect two transmission oil cooler lines from transmission oil cooler radiator fittings.
8. On 3.0L / 3.OL FF remove two upper radiator retaining screws.
9. On 3.OL / 3.2L SHO and 3.8L engines remove two hex nuts from RH radiator support bracket. Remove bracket.
10. On 3.0L / 3.2L SHO and 3.8L engines remove two screws from LH radiator support bracket. Remove bracket.
