Taurus V6-195 3.2L DOHC SHO (1994)
Oil Pump: Service and Repair
Removal and Installation
1.
Relieve fuel system pressure.
2.
Disconnect battery ground cable, then remove oil dipstick.
3.
Remove accessory drive belts, then timing belt.
Fig. 19 Oil Pan & Pump Removal
4.
Raise and support vehicle. Remove low oil sensor retainer clip at sensor, then disconnect electrical connector.
5.
Drain crankcase.
6.
Remove starter motor, then disconnect Heated Exhaust Gas Oxygen (HEGO) sensor electrical connector.
7.
Remove catalyst and pipe assembly.
8.
Remove lower engine/flywheel dust cover from converter housing.
9.
Remove oil pan gasket, then timing belt pulley.
10.
Remove pickup tube to oil pump attaching bolts.
11.
Remove oil pump to block attaching bolts, then remove pump.
12.
Reverse procedure to install, noting the following:
a. Torque oil pump bolts to 11-16 ft lb.
