Taurus V6-195 3.2L DOHC SHO (1994)
Grommets
8. Install grommets between timing belt tensioner and oil pump.
9. Remove 1.5 mm (1/20 inch) hex wrench from timing belt tensioner.
Note:
-
If a new timing belt is being installed, perform steps 10 through 13.
-
If the original timing belt is being used, go to step 14.
Special Tool - Timing Belt Tensioner
10. Position Timing Belt Tensioner Tool T93P-6254-B using holes in power steering pump support.
Lightly tighten timing belt tensioner adjustment bolt to bottom the timing belt tensioner idle pulley to prevent it from pivoting during adjustment.
Idler Pulley Torquing
11. Hand-tighten timing belt tensioner idler pulley bolt.
12. Using Inch Pound Torque Wrench D81L-600-A or equivalent, rotate Torque Wrench Attachment T93P-6254-A clockwise to 0.5 Nm (4.3 In lbs).
13. Tighten timing belt tensioner idler pulley bolts to 36-50 Nm (27-37 ft lbs).
Then remove Belt Tensioning Tool T93P-6254-B and Torque Wrench Attachment T93P-6254-A.
