Taurus V6-195 3.2L DOHC SHO (1994)
2.
Refer to the table for wire color codes and splices to be used.
3.
Strip wires 0.5 inch (7.6 mm), then insert each wire into correct crimp barrel.
4.
Using Crimp Tool (AD-1522), crimp all wires.
5.
Heat splice with heat gun until tubing shrinks and adhesive flows from each end.
6.
Temporarily connect new headlamp switch and install knob.
7.
Connect battery negative cable.
8.
Check operation of headlights, marker lights, tail lights and instrument panel lights.
9.
Disconnect battery negative cable.
10.
Remove headlamp knob and disconnect headlamp switch.
11.
Fold wiring back in an "S" onto the harness and wrap with electrical tape to allow the extra wiring to be fitted into the instrument panel. See Figure
11.
12.
Return to Step 12 on this attachment for Sable vehicles or Step for Taurus vehicles.
TAURUS/SABLE (NON AUTO LAMP VEHICLES HARNESS KIT PART # F8DZ-11654-EA)
1.
Remove headlamp switch connector from the wire harness by cutting the wires 1/2 inch (13 mm) from the connector. Discard the old connector.
