Taurus V6-195 3.2L DOHC SHO (1994)
11. Install Hub Remover/Installer Adapter T81P-1104-A with Front Hub Remover/Replacer T81P-1104-C and Wheel Bolt Adapters T83P-1104-BH1
and Two Stud Adapter T86P-1104-A1 or equivalent and remove hub, bearing and knuckle assembly by pushing out CV joint outer shaft until it is
free of assembly.
12. Support front wheel knuckle with a length of wire, remove strut bolt and front wheel hub and spindle (3K206)/ wheel hub/ front wheel knuckle
assembly off front spring and shock.
13. Carefully remove support wire, and carry hub/bearing/knuckle assembly to a bench.
Front Hub Puller
14. On the bench, install Front Hub Puller D80L-1002-L and Shaft Protector D80L-625-1 or equivalent, with jaws of puller on knuckle bosses and
remove hub.
Note: Ensure the shaft protector is centered, clears the bearing ID, and rests on the end face of the hub journal.
15. Remove snap ring, which retains bearing in knuckle assembly, with snap ring pliers and discard.