Taurus V6-195 3.2L DOHC SHO (1994)
Child Seat Tether Attachment: Service and Repair
The child safety belt anchor tether kit can be obtained at no charge from any Ford or Lincoln/Mercury dealer.
WARNING: WHEN USING ANY INFANT OR CHILD RESTRAINT SYSTEM, IT IS IMPORTANT THAT YOU FOLLOW THE
INSTRUCTIONS PROVIDED BY THE MANUFACTURER CONCERNING ITS INSTALLATION AND USE. FAILURE TO FOLLOW
EACH OF THE RESTRAINT MANUFACTURER'S INSTRUCTIONS CAN RESULT IN A CHILD STRIKING THE VEHICLE'S
INTERIOR DURING A SUDDEN STOP OR COLLISION.
WARNING: IT IS IMPORTANT THAT THE BOLT/ANCHOR BE SECURELY TIGHTENED TO SPECIFICATION. OTHERWISE, THE
CHILD SAFETY SEAT MAY NOT BE PROPERLY SECURED, AND THE CHILD COULD BE INJURED IN CASE OF A SUDDEN STOP
OR COLLISION.
To install, follow instructions provided with the child safety belt anchor tether kit.
TETHER ATTACHMENT LOCATION
Dimension A is the distance from the center line of the vehicle to the center of the tether attachment holes.
Dimension B is the approximate distance from the center of the radio speaker grille opening to the center of the tether attachment holes.
TETHER ATTACHMENT
Rear Window Tray - Sedan
On Sedan models, three (one each side and one near the center) 9mm diameter (0.35 inch) top tether attachment holes in the trim panel structure
(behind the rear seat) have been provided for attachment of the child safety belt anchor tether hardware supplied with the child's safety seat, if required.
For easy identification, these holes are marked with the letter "T" stamped behind the hole.
Wagon Without Auxiliary Seat
On all Wagon models, two (one each side) steel U-shaped load floor anchors located on the forward auxiliary floor trim panel have been provided for
attachment of the child safety belt anchor tether. The tether anchors are easily accessed by inserting a small screwdriver under the attachment anchor
covers and prying them off the anchors.
WARNING: IF THE ANCHOR BOLTS ARE EVER REMOVED, THE HOLE(S) IN THE FLOOR MUST BE SEALED TO PREVENT THE
