Taurus V6-195 3.2L DOHC SHO (1994)
Rack Seal From Rack Bushing Removal
8. Position rack bushing, seal end first, into rack bushing holding tool T78P-3504-L, or equivalent, then place tool and bushing in a vise. With rack
oil seal remover T78P-3504-J, or equivalent, and a suitable slide hammer, remove seal.
9. Remove O-rings from bushing with O-ring tool T71P-19703-C, or equivalent.
ASSEMBLY
1. Apply grease to rack high pressure oil seal, position seal on tool T78P-3504-K, or equivalent, with lip spring facing tool. Place gear housing in
vertical position, then place tool into right side of housing. Tap on tool handle until seal is seated. Use care not to cock handle of tool when
installing seal.
2. Mark center tooth of rack so that it will be visible through valve bore.
3. Install rubber O-ring into groove on rack piston.
