Taurus V6-195 3.2L DOHC SHO (1994)
Index
Wheel hubs and front wheel bearings are installed as follows:
-
Each front wheel is bolted to a wheel hub.
-
There are two opposed tapered roller front wheel bearings (inner and outer) with grease retainer seals (inner and outer), encased in one single cup
or cartridge.
-
This front wheel bearing assembly is pressed into the LH front wheel knuckle/RH front wheel knuckle bore from the inboard side until it rests
against the shoulder on the outboard side.
-
A snap ring is installed in a groove on the inboard side of the LH front wheel knuckle/RH front wheel knuckle bore for added bearing retention. A
bearing front wheel dust shield (3K070) is installed on the front wheel knuckle inboard of the front wheel knuckle / front wheel bearing / wheel
hub assembly.
-
The wheel hub assembly is pressed into the front wheel bearing / front wheel knuckle.
-
The front wheel driveshaft and joint splined shaft is pressed through the wheel hub.
-
A prevailing torque front axle wheel hub retainer and washer retain the wheel hub assembly to the front wheel driveshaft and joint.
