Taurus V6-195 3.2L DOHC SHO (1994)
Note: Apply a small amount of Disc Brake Caliper Slide Grease D7AZ-19590-A (ESA-M1C172-A) or equivalent to pilot diameter of rotor.
11. Install front disc brake rotor shield.
12. Install disc brake rotor to hub assembly.
13. Install disc brake caliper over rotor.
14. Install wheel and tire assembly, tightening wheel lug nuts finger-tight.
15. Lower vehicle and block wheels to prevent vehicle from rolling.
WARNING: REPLACEMENT LUG NUTS OR STUDS MUST BE OF THE SAME TYPE AND SIZE AS THOSE BEING REPLACED.
16. Tighten wheel nuts to 115-142 NM (85-105 ft-lbs).
17. Install wheel hub cap or hub grease cap (1131) and lower vehicle completely to the ground.
18. Remove wheel blocks.
