Taurus V6-232 3.8L (1989)
Fuel Injector: Service and Repair
REMOVAL
Fuel Injector
1.
Disconnect battery ground cable and secure it out of the way.
2.
Remove fuel cap.
3.
Release pressure from fuel system.
4.
Remove upper intake manifold, see UPPER INTAKE MANIFOLD.
5.
Remove fuel supply manifold, see FUEL SUPPLY MANIFOLD.
6.
Remove injector retain clips.
7.
Carefully remove electrical harness connectors from individual injectors.
Fuel Injector
8.
Grasping injector body, pull up gently while rocking injector from side to side.
Fuel Injector
9.
Inspect injector O-rings (two per injector) for signs of deterioration. Replace as required.
10.
Inspect injector "plastic hat" (covering the injector pintle) and washer for signs of deterioration. Replace as required. If hat is missing, look for it
in the intake manifold.
INSTALLATION
1.
Lubricate new O-rings with light grade oil and install two on each injector.
NOTE: Never use silicone grease. It will clog the injectors.
2.
Install injector(s). Use a light, twisting, pushing motion to install them.
3.
Reconnect injector retaining clips.
4.
Install fuel rail assembly, as outlined in this section.
