Taurus V6-3.0L DOHC VIN S (2000)
Arm/Disarm Switch: Service and Repair
REMOVAL
1. Disconnect the battery ground cable. Refer to Battery.
2. Remove the door trim panel.
3. Remove the watershield.
4. Disconnect the latch lever from the door lock cylinder.
1
Remove the E-clip.
2
Disconnect the latch lever.
5. Remove the door disarm switch.
^
Disconnect disarm switch electrical connector.
NOTE: The door disarm switch can be installed in more than one position. Before removing the switch from the cylinder it may be necessary
to mark the position of the switch in relation to the lock cylinder.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: The door disarm switch can be installed in more than one position. Use the reference marks applied in the removal procedure to index the
new door disarm switch to the lock cylinder.