Taurus V6-3.0L DOHC VIN S (2000)
1. Install the seat position sensor.
^
Turn the sensor until the locking tab locks into place.
2. Connect the electrical connector.
3. Remove the driver safety belt pretensioner restraint system diagnostic tool from the ten-pin floor electrical connector.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
4. Position the seat into the vehicle. Connect the ten-pin floor electrical connector to the driver seat.
5. Install the seat rear nuts.
