ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Manual Seats|Page 8716 > < Manual Seats|Page 8714
Page 1
background image

Power Seat Motor Position Sensor: Service and Repair
Power Seats

WARNING:

^

ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING AN AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) VEHICLE
AND WHEN HANDLING AN AIR BAG MODULE.THIS WILL REDUCE THE RISK OF INJURY IN THE EVENT OF AN
ACCIDENTAL DEPLOYMENT.

^

AFTER DEPLOYMENT, THE AIR BAG SURFACE CAN CONTAIN DEPOSITS OF SODIUM HYDROXIDE, A PRODUCT OF THE
GAS GENERANT COMBUSTION THAT IS IRRITATING TO THE SKIN.WASH YOUR HANDS WITH SOAP AND WATER
AFTERWARD.

^

NEVER PROBE THE CONNECTORS ON THE AIR BAG MODULE. DOING SO CAN RESULT IN AIR BAG DEPLOYMENT,
WHICH CAN RESULT IN PERSONAL INJURY.

^

VEHICLE SENSOR ORIENTATION IS CRITICAL FOR PROPER SYSTEM OPERATION.IF A VEHICLE EQUIPPED WITH AN
AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) IS INVOLVED IN A COLLISION, INSPECT THE SENSOR MOUNTING
BRACKET AND WIRING PIGTAIL FOR DEFORMATION. REPLACE AND PROPERLY POSITION THE SENSOR OR ANY
OTHER DAMAGED SUPPLEMENTAL RESTRAINT SYSTEM (SRS) COMPONENTS WHETHER OR NOT THE AIR BAG IS
DEPLOYED.

^

TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BACKUP POWER SUPPLY MUST BE
DEPLETED BEFORE REPAIRING OR REPLACING ANY FRONT OR SIDE AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM
(SRS) COMPONENTS AND BEFORE SERVICING, REPLACING, ADJUSTING OR STRIKING COMPONENTS NEAR THE
FRONT OR SIDE AIR BAG SENSORS, SUCH AS DOORS, INSTRUMENT PANEL, CONSOLE, DOOR LATCHES, STRIKERS,
SEATS AND HOOD LATCHES. PLEASE REFER TO THE APPROPRIATE VEHICLE SHOP MANUAL TO DETERMINE
LOCATION OF THE FRONT AIR BAG SENSORS. THE SIDE AIR BAG SENSORS ARE LOCATED AT OR NEAR THE BASE OF
THE B-PILLAR.
TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND WAIT AT
LEAST ONE MINUTE. BE SURE TO DISCONNECT AUXILIARY BATTERIES AND POWER SUPPLIES (IF EQUIPPED).

^

THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY.REMOVE FROM VEHICLE
PRIOR TO ROAD USE.FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF VEHICLE
SAFETY STANDARDS.

NOTE:

^

If a seat equipped with a seat mounted side airbag and/or a safety belt pretensioner (if equipped) system is being serviced the airbag system must
be deactivated per the deactivation procedure contained in Air Bag Systems of the appropriate car/truck service manual.

^

Airbag simulators (restraint system diagnostic tools) MUST be installed under the seats in the side airbag and safety belt pretensioner (if equipped)
to floor connectors.

^

Diagnostics or repairs are not to be performed on a side airbag system and/or safety belt pretensioner (if equipped) with the seats in the vehicle.
Prior to attempting to diagnose/repair the side airbag system and/or safety belt pretensioner (if equipped) the seats must be removed from the
vehicle and the restraint system diagnostic tools must be installed in the side airbag and the safety belt pretensioner (if equipped) connectors at the
floor connectors. The restraint system diagnostic tools must be removed prior to operating the vehicle over the road.

^

Diagnostics may be performed on seat systems other than the side airbag or the safety belt pretensioner (if equipped) system (lumbar, climate
controlled, heated, power seat track) with the seat installed in the vehicle as long as the restraint system diagnostic tools are installed under the
seats in the side airbag and safety belt pretensioner to floor connectors.

^

After diagnosing/repairing a seat system, the restraint system diagnostic tools must be removed before operating the vehicle over the road.

^

Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.

^

The driver seat is shown, the passenger seat is similar.

REMOVAL

1. Move and tilt the front seats to their highest and rearmost position.
2. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to Battery.

3. Disconnect the driver seat side air bag electrical connector (if equipped).
4. Attach a restraint system diagnostic tool to the driver seat side air bag floor electrical connector (if equipped).

Manual Seats|Page 8716 > < Manual Seats|Page 8714