Taurus V6-3.0L DOHC VIN S (2000)
^
NEVER PROBE THE CONNECTORS ON THE AIR BAG MODULE. DOING SO CAN RESULT IN AIR BAG DEPLOYMENT, WHICH
CAN RESULT IN PERSONAL INJURY.
^
VEHICLE SENSOR ORIENTATION IS CRITICAL FOR PROPER SYSTEM OPERATION. IF A VEHICLE EQUIPPED WITH AN AIR BAG
SUPPLEMENTAL RESTRAINT SYSTEM (SRS) IS INVOLVED IN A COLLISION, INSPECT THE SENSOR MOUNTING BRACKET AND
WIRING PIGTAIL FOR DEFORMATION. REPLACE AND PROPERLY POSITION THE SENSOR OR ANY OTHER DAMAGED
SUPPLEMENTAL RESTRAINT SYSTEM (SRS) COMPONENTS WHETHER OR NOT THE AIR BAG IS DEPLOYED.
^
TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BACKUP POWER SUPPLY MUST BE
DEPLETED BEFORE REPAIRING OR REPLACING ANY FRONT OR SIDE AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
COMPONENTS AND BEFORE SERVICING, REPLACING, ADJUSTING OR STRIKING COMPONENTS NEAR THE FRONT OR SIDE
AIR BAG SENSORS, SUCH AS DOORS, INSTRUMENT PANEL, CONSOLE, DOOR LATCHES, STRIKERS, SEATS AND HOOD
LATCHES.
PLEASE REFER TO THE APPROPRIATE VEHICLE SHOP MANUAL TO DETERMINE LOCATION OF THE FRONT AIR BAG
SENSORS.
THE SIDE AIR BAG SENSORS ARE LOCATED AT OR NEAR THE BASE OF THE B-PILLAR.
TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND WAIT AT LEAST
ONE MINUTE. BE SURE TO DISCONNECT AUXILIARY BATTERIES AND POWER SUPPLIES (IF EQUIPPED).
^
THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM VEHICLE PRIOR
TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF VEHICLE SAFETY
STANDARDS.
NOTE:
^
If a seat equipped with a seat mounted side airbag and/or a safety belt pretensioner (if equipped) system is being serviced the airbag system must
be deactivated per the deactivation procedure contained in Air Bag Systems of the appropriate car/truck service manual.
^
Airbag simulators (restraint system diagnostic tools) MUST be installed under the seats in the side airbag and safety belt pretensioner (if equipped)
to floor connectors.
^
Diagnostics or repairs are not to be performed on a side airbag system and/or safety belt pretensioner (if equipped) with the seats in the vehicle.
Prior to attempting to diagnose/repair the side air bag system and/or safety belt pretensioner (if equipped) the seats must be removed from the
vehicle and the restraint system diagnostic tools must be installed in the side airbag and the safety belt pretensioner (if equipped) connectors at the
floor connectors. The restraint system diagnostic tools must be removed prior to operating the vehicle over the road.
^
Diagnostics may be performed on seat systems other than the side airbag or the safety belt pretensioner (if equipped) system (lumbar, climate
controlled, heated, power seat track) with the seat installed in the vehicle as long as the restraint system diagnostic tools are installed under the
seats in the side airbag and safety belt pretensioner to floor connectors.
^
After diagnosing/repairing a seat system, the restraint system diagnostic tools must be removed before operating the vehicle over the road.
^
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
^
The driver seat safety belt buckle and pretensioner is shown, the passenger side is similar.
REMOVAL
1. Move and tilt the front seats to their highest and rearmost position.
2. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to Battery.
3. Attach a restraint system diagnostic tool to the driver seat side air bag floor electrical connector (if equipped).
4. Disconnect the driver seat side air bag (if equipped) and ten-pin electrical connectors.
5. Attach the diagnostic tool(s) to the driver seat electrical connector(s).
1
Attach a driver safety belt pretensioner restraint system diagnostic tool to the ten-pin floor electrical connector.
2
Attach a restraint system diagnostic tool to the driver seat side air bag floor electrical connector (if equipped).
NOTE: The restraint system diagnostic tools for the driver and passenger safety belt pretensioners are similar but not interchangeable. Make
