Taurus V6-3.0L DOHC VIN S (2000)
22. Remove the bolts.
23. Remove the seat track.
INSTALLATION
1. Position the seat track and install the bolts.
2. Install the seat backrest. For additional information, refer to Front Seat Backrest-Driver Side or Front Seat Backrest-Passenger Side.
3. Remove the diagnostic tools from the driver seat electrical connectors.
1
Remove the driver safety belt pretensioner restraint system diagnostic tool from the ten-pin floor electrical connector.
2
Remove the restraint system diagnostic tool from the driver seat side air bag floor electrical connector (if equipped).
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE
FROM VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION
OF VEHICLE SAFETY STANDARDS.
4. Position the seat into the vehicle.
5. Connect the driver seat side air bag electrical connector (if equipped) and ten-pin electrical connector.
