Taurus V6-3.0L DOHC VIN S (2000)
3. Connect a clear drain tube to the RH rear bleeder screw and the other end in a container partially filled with recommended brake fluid.
All vehicles
4. Have an assistant pump the brake pedal and then hold firm pressure on the brake pedal.
5. Loosen the RH rear bleeder screw until a stream of brake fluid comes out. While the assistant maintains pressure on the brake pedal, tighten the
bleeder screw.
-
Repeat until clear, bubble-free fluid comes out.
-
Refill the brake master cylinder reservoir as necessary.
Vehicles with rear drum brakes
6. Tighten the bleeder screw.
Vehicles with rear disc brakes
7. Tighten the bleeder screw.
All vehicles
8. Repeat Steps 2 - 7 for the LH rear bleeder screw, the RH front bleeder screw and the LH front bleeder screw, in that order.
9. Note: Go to the help menu on the scan tool. The Ford Service Function Card (FSF) must be used to get the help menu.
Connect the NGS DLC cable adapter into the vehicle data link connector (DLC) under the dash, and follow the scan tool instructions for bleeding.
10. Repeat the conventional bleed procedure as outlined in Steps 2 - 7.
