Taurus V6-3.0L DOHC VIN S (2000)
Refrigerant Pressure Sensor / Switch: Service and Repair
Pressure Cutoff Switch
REMOVAL
1. Raise and support the vehicle. Refer to Maintenance/Service and Repair.
2. Disconnect the pressure cutoff switch electrical connector.
3. Remove the pressure cutoff switch. Remove and discard the O-ring seal.
-
During installation, install a new O-ring seal lubricated with PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft
YN-12-C), or equivalent meeting Ford specification WSH-M1C231-B.
INSTALLATION4
1. To install, reverse the removal procedure.