Taurus V6-3.0L DOHC VIN S (2000)
8. Pull up and out to release the retaining clips, route the safety belt out and remove the lower B-pillar trim panel.
9. Remove the safety belt guide.
1
Remove the pin-type retainer.
2
Rotate the safety belt guide out from the bottom.
3
Pull out and remove the safety belt guide.
10. Remove the safety belt retractor.
1
Using special tool 501-010 (T77L-2100-A), remove the bolt.
2
Remove the safety belt retractor.
11. To install, reverse the removal procedure.
^
See the removal procedure or Specifications for torque specifications.
NOTE:
^
Make sure the safety belt webbing is not twisted prior to installation.
^
Make sure to tighten nuts and bolts to specification.
^
If the safety belt guide cover is damaged or if it does not remain closed, install a new cover.
12. Check the restraint system for correct operation.
