Taurus V6-3.0L DOHC VIN S (2000)
6. Install the seat rear trim covers.
7. Connect the battery ground cable. For additional information, refer to Battery.
8. With the restraint system diagnostic tools still in place, prove out the air bag system.
9. Position the seat to its rearmost position.
10. Disconnect the battery ground cable and wait at least one minute.For additional information, refer to Battery.
11. Install the seat front bolts.
12. Install the seat front trim covers.
13. Remove the restraint system diagnostic tool from the seat side air bag floor electrical connector (if equipped).
14. Connect the seat side air bag (if equipped) electrical connector.
15. Remove the diagnostic tool(s) from the passenger seat electrical connector(s).
1
Remove the passenger safety belt pretensioner restraint system diagnostic tool from the ten-pin floor electrical connector.
2
Remove the restraint system diagnostic tool from the passenger seat side air bag floor electrical connector (if equipped).
