Taurus V6-3.0L DOHC VIN S (2000)
6. Connect the electrical connectors.
1
Connect the power seat track electrical connector (if equipped).
2
Connect the power pedal electrical connector (if equipped).
7. Remove the driver safety belt pretensioner restraint system diagnostic tool from the ten-pin floor electrical connector.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
8. Position the driver seat into the vehicle. Connect the ten-pin floor electrical connector to the driver seat.
9. Install the driver seat rear nuts.
10. Install the driver seat rear trim covers.
11. Connect the battery ground cable. For additional information, refer to Battery.
12. With the restraint system diagnostic tools still in place, prove out the air bag system.
