Taurus V6-3.0L DOHC VIN S (2000)
13. Position the driver seat to its rearmost position.
14. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to Battery.
15. Install the driver seat front bolts.
16. Install the driver seat front trim covers.
17. Remove the restraint system diagnostic tool from the driver seat side air bag floor electrical connector (if equipped).
18. Connect the driver seat side air bag (if equipped) electrical connector.
19. Remove the diagnostic tool(s) from the passenger seat electrical connector(s).
1
Remove the passenger safety belt pretensioner restraint system diagnostic tool from the ten-pin floor electrical connector.
2
Remove the restraint system diagnostic tool from the passenger seat side air bag floor electrical connector (if equipped).
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE
FROM VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION
OF VEHICLE SAFETY STANDARDS.
