Taurus V6-3.0L DOHC VIN S (2000)
VEHICLE PRIOR TO ROAD USE.FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF VEHICLE
SAFETY STANDARDS.
8. Position the seat into the vehicle. Connect the ten-pin floor electrical connector to the passenger seat.
9. Install the passenger seat rear nuts.
10. Install the passenger seat rear trim covers.
11. Connect the battery ground cable. For additional information, refer to Battery.
12. With the restraint system diagnostic tools still in place, prove out the air bag system.
13. Position the passenger seat to its rearmost position.
14. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to Battery.
15. Install the passenger seat front bolts.
