Taurus V6-3.0L DOHC VIN S (2000)
10. Note: If the hole in the tie-rod end does not line up with the slots in the nut, continue tightening the nut. Do not loosen the nut to align the slots in
the nut with the hole in the outer tie-rod end.
Connect the tie-rod end to the knuckle and install a new nut and cotter pin.
11. Install the brake disc.
12. CAUTION: The front axle wheel hub retainer must be tightened to specification immediately during installation. If the retainer is not tightened
immediately, the nylon lock will set incorrectly, leading to incorrect torque readings and bearing failure. Any front wheel hub retainer that is not
immediately tightened to specification or is loosened must be removed and a new retainer installed.
Install the washer, the wheel hub retainer and the hub cap or wheel cover.
