Taurus V6-3.0L DOHC VIN S (2000)
package (F85Z-11582-AA). The lock repair package includes a detailed instruction sheet to build the new lock cylinder to the current key code of
the vehicle.
Remove the ignition switch lock cylinder.
-
Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
-
Use a 3/8-inch drill bit to drill down the middle of the ignition lock key slot until the ignition switch lock cylinder breaks loose.
-
Remove and discard the ignition switch lock cylinder and clean the drill shavings from the steering column.
5. Remove the bearing retainer.
6. Remove the bearing and gear.
-
Thoroughly clean all drill shavings from the steering column and inspect it for damage.
Installation
1. Install the gear and the bearing.
2. Install the bearing retainer.
