Taurus V6-3.0L DOHC VIN S (2000)
5. Remove and discard the two flag nuts and bolts. Remove the upper control arm.
Installation
1. Position the upper control arm and install two new bolts and flag nuts.
-
Do not tighten the bolts at this time.
2. Attach the upper control arm and install a new nut.
3. Using a jack stand, raise the suspension until the distance between the center of the hub and the lip of the fender is equal to the measurement taken
in Removal procedure (curb height).
4. Tighten the two bolts.
5. Lower the suspension and remove the jack stand.
6. Install the wheel and tire assembly.
7. Check the wheel alignment. Adjust as necessary.
