Taurus V6-3.0L DOHC VIN S (2000)
16. Note: Remove all excess grease from the front wheel driveshaft joint external surface and the front wheel driveshaft joint boot mating surface.
Seat the front wheel driveshaft joint boot in the front wheel driveshaft joint boot groove.
17. Install the clamp as tight as possible by hand.
18. Using the special tool, tighten the clamp.
-
Position the special tool on the clamp ear, and tighten the tool through bolt until the tool closes completely.
Halfshaft-Inboard, Ford
Disassembly