Taurus V6-3.0L DOHC VIN S (2000)
5. If installing the original windshield glass, remove the excess urethane sealant.
6. Clean the inside of the windshield glass surface with a non-alcohol based glass cleaner.
7. If installing a new windshield glass, apply Urethane Glass Prep Essex U-401 meeting Ford specification WSB-M5B314-B to the area to be
urethaned.
CAUTION: Wipe off the Urethane Glass Prep Essex U-401 meeting Ford specification WSB-M5B314-B immediately after each application
because it flash dries.
8. If installing a new windshield glass, apply Urethane Glass Primer Essex U-402 meeting Ford specification WSB-M5B280-C to the same area in
the previous step. Allow five to seven minutes to dry.
9. Cut the urethane sealant applicator tip to specification.
10. Apply Urethane Sealant Essex U-216 or Essex 400-HV meeting Ford specification WSB-M2G316-B on top of the existing trimmed urethane
adhesive head on the pinch weld. Make sure that all gaps in the urethane sealant are smoothed into one continuous bead.
CAUTION: If vehicle is to driven within 24 hours of urethane application, Urethane Sealant Essex U-216 meeting Ford specification
WSB-M2G316-B must be used due to its one hour cure time.
11. Install the windshield glass on the vehicle aligning it with the markings made previously.
12. Check the windshield installation for air or water leaks through the urethane seal.
13. Position the headliner.
14. If equipped, install the dome lamp assembly. For additional information, refer to Lighting and Horns.
15. Install the two sun visor clips, the LH and RH sun visors, and the eight screws.
