Taurus V6-3.0L VIN 2 Flex Fuel (1997)
Ignition Coil: Service and Repair
Ignition Coil Pack
REMOVAL
1. Disconnect fuel charging wiring connectors from ignition coil and radio ignition interference capacitor.
Removing Ignition Wires At Coil Pack
2. Disconnect ignition wires by squeezing locking tabs and twisting while pulling upward.
3. Remove four ignition coil retaining screws and remove ignition coil and radio ignition interference capacitor. Save radio ignition interference
capacitor for installation with ignition coil.
INSTALLATION
1. Position ignition coil and radio ignition interference capacitor to ignition coil bracket.
2. Install retaining screws and tighten to 5-7 Nm (45-61 lb in).
3. Apply Silicone Dielectric Compound D7AZ-19A331-A (Motorcraft WA-10) or equivalent meeting Ford specification ESE-M1C171-A to all
ignition wire boots.
4. Install each ignition wire connector to the proper terminal on the ignition coil. Make sure ignition coil boots are fully seated.
5. Connect engine control sensor wiring to the ignition coil and radio ignition interference capacitor.
