Taurus V6-3.0L VIN 2 Flex Fuel (1997)
1. To install, reverse removal procedure.
2. Make sure the safety belt webbing is not twisted. If it is, remove the twist.
3. Tighten all anchor bolts to 34-46 Nm (25-33 lb ft) for each mounting position.
4. Check the restraint system for proper operation.
Third Row
REMOVAL
1. Remove nut and guide from mounting stud.
2. Hold stud stationary at the hex collar that is located behind the quarter trim panel and remove quarter trim panel.
3. Remove stowage compartment door and hinge.
4. Remove bolt and seat belt anchor from rear floor pan.
5. Remove bolt and auxiliary seat belt and retractor assembly from vehicle.
6. Remove trim bezel.
7. Remove seat belt and webbing from quarter trim panel.
INSTALLATION