Taurus V6-3.0L VIN 2 Flex Fuel (1997)
10. Install bore spring between case and tab on outer vane support.
O-ring Service
11. Install new rubber O-ring in groove in outer vane support. Then, install metal O-ring retainer.
Pump Gear Alignment
12. Install pump cover on pump housing and install retaining bolts. Tighten bolts evenly to 9-12 Nm (80-106 inch lbs.).
NOTE:
^
Use the pump assembly shaft to align the pump gears while installing the pump cover.
^
Make sure that pivot pin is flush with or below the surface of the main control valve body side of the pump assembly.
