Taurus V6-3.0L VIN U (2000)
Seat Belt Retractor: Service and Repair
Rear Center Safety Belt Retractor - Four Door
Seat Belt Bolt Bit
Special Service Tool(s)
REMOVAL AND INSTALLATION
NOTE: New safety belt buckles, height adjusters, center adjust tongues and belts and retractors can be installed separately. However, if a safety belt
assembly was in use during a collision, a new belt and retractor must be installed as well as the center adjust tongue and belt and buckle assembly or the
center adjust tongue and the cable and buckle assembly. When installing new safety belts and buckles, height adjusters, safety cables and buckles, center
adjust tongues and belt and retractors, use only the parts specified in the Ford Master Parts Catalogs for the make and model of the vehicle being
repaired. Safety belt assemblies must not be interchanged between vehicle models.
1. Push in and pull up releasing the second row seat cushion and remove it
2. Remove the safety belt anchor and buckle assembly.
1
Remove the retaining nut.
2
Remove the safety belt anchor and buckle assembly.
3. Push up at the split and remove the seat back safety belt guide.