Taurus V6-3.0L VIN U (2000)
17. Separate the quarter trim panel from the body.
1
Remove the retaining screws.
2
Pull out to release the retaining clips at the C-pillar, lift the storage compartment up and out, and separate the quarter trim panel from the body.
Both sides
18. Remove the second row safety belt anchor.
1
Using special tool 501-010 (T77L-2100-A), remove the bolt.
2
Remove the safety belt anchor.
19. Route the second row (if necessary) and third row (if necessary) safety belt anchors out and remove the quarter trim panel (if necessary).
20. Remove the second row safety belt guide.
1
Remove the bolt.
2
Remove the safety belt guide.
21. Remove the second row safety belt retractor.
1
Using special tool 501-010 (T77L-2100-A), remove the bolt.
2
Remove the second row safety belt retractor.
22. To install, reverse the removal procedure.
^
See the removal procedure or Specifications for torque specifications.
NOTE:
^
Make sure the safety belt webbing is not twisted prior to installation.
^
Make sure to tighten nuts and bolts to specification.
^
Make sure that the safety belt buckles are accessible after seat installation.
^
If the safety belt guide cover is damaged or if it does not remain closed, install a new cover.
23. Check the restraint system for correct operation.
