Taurus AWD V6-3.5L (2009)
-------------------------------------------------
C4 CHECK THE SJB VOLTAGE SUPPLY
-
Measure and record the voltage at the battery.
-
Disconnect: SJB C2280g.
-
Ignition ON.
-
Measure the voltage between the SJB C2280g-1, circuit SBB01 (RD), harness side and ground.
-
Is the voltage within 0.2 volt of the recorded battery voltage?
Yes
GO to C5.
No
REPAIR the circuit for high resistance. CLEAR the DTC. REPEAT the self-test.
-------------------------------------------------
C5 CHECK THE SJB GROUND CIRCUIT
-
Ignition OFF.
-
Disconnect: Negative Battery Cable.
-
Disconnect: SJB C2280d.
-
Measure the resistance between the SJB C2280d-8, C2280d-12, circuit GD133 (BK), harness side and ground.
-
Is the resistance less than 5 ohms?
Yes
CONNECT the negative battery cable. GO to C6.
No
REPAIR the circuit for high resistance. CONNECT the negative battery cable. TEST the system for normal operation.
-------------------------------------------------
C6 CHECK FOR CORRECT SJB OPERATION
-
Disconnect the SJB connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the SJB connectors and make sure they seat correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes