Taurus AWD V6-3.5L (2009)
-
To install, tighten to 10 Nm (89 lb-in).
12. Remove the safety belt buckle pretensioner nut and safety belt buckle pretensioner.
-
To install, tighten to 50 Nm (37 lb-ft).
All seats
13. Release the fasteners at the rear of the cushion trim cover.
-
Driver seats and passenger seats equipped with an OEM Occupant Classification Sensor (OCS), remove the foam pad and trim cover.
-
When installing, make sure the safety belt buckle pretensioner is positioned through the seat cushion trim cover opening.
14. Disconnect and detach the electrical connector(s) from the seat track bracket.
15. Disconnect the Supplemental Restraint System (SRS) seat position sensor electrical connector.
16. NOTE: Before disconnecting the power seat track motor electrical connectors, determine which connector goes to each motor and label to aid in
installation.
If equipped, disconnect all the power seat track motor electrical connectors.
Passenger seat
17. NOTE: Make sure the pressure sensor is correctly installed and retained to the seat track bracket and the pressure sensor hose is not kinked during
installation.
Bend the tab and slide the pressure sensor off the seat track bracket.
-
When installing, bend the tab back before sliding the pressure sensor onto the bracket.
Power passenger seat with an Occupant Classification Sensor (OCS) system service kit
18. Detach the OCS system service kit electrical connector from the seat track.
Manual passenger seat with an OCS system service kit
19. Detach the OCS system service kit OCSM and seat wiring harness electrical connector.
1. Detach the OCS system service kit electrical connector from the seat track.
