Taurus AWD V6-3.5L (2009)
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
NOTICE: Do not allow the brake fluid to come in contact with the adhesive backing on the brake pads. This may prevent the brake pad
adhesive surface from bonding with the brake caliper. If brake fluid is spilled onto the brake pads, new pads must be installed.
NOTICE: Use only specified brake parts cleaner. Use of other cleaners may leave a residue on the brake caliper preventing the brake pads
adhesive surface from bonding with the brake caliper.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: New brake flexible hoses are supplied with new calipers. The brake flexible hose can be installed separately from the brake caliper.
Disconnect the brake tube fitting from the brake flexible hose.
-
To install, tighten to 17 Nm (150 lb-in).
3. Remove the retaining clip from the brake flexible hose.
4. Disconnect the brake flexible hose from the brake caliper.
-
To install, tighten to 25 Nm (18 lb-ft).
5. To install, reverse the removal procedure.
-
Bleed the brake caliper.
