Taurus AWD V6-3.5L (2009)
-
Tighten in the sequence shown to 10 Nm (89 lb-in).
14. NOTE: Make sure the dowels on the VCT housing are fully engaged in the cylinder head prior to tightening the bolts.
Install the RH VCT housing and the 3 bolts.
-
Tighten in the sequence shown to 10 Nm (89 lb-in).
15. NOTE: Lubricate the engine oil filter gasket with clean engine oil prior to installing the oil filter.
Install a new engine oil filter.
-
Tighten to 5 Nm (44 lb-in) and then rotate an additional 180 degrees.
16. Install the engine front cover.
17. Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding See: Service and
Repair/Cooling System Draining, Filling and Bleeding.
