Taurus AWD V6-3.5L (2009)
Exhaust Pipe: Service and Repair
Exhaust Y-Pipe
Exhaust Y-Pipe
Removal and Installation
1. NOTE: Always install new fasteners and gaskets. Clean flange faces prior to new gasket installation to make sure of correct sealing.
With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 2 exhaust Y-pipe-to-intermediate pipe nuts.
-
Discard the nuts and gasket.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the 2 exhaust Y-pipe-to-LH catalytic converter nuts, the 2 exhaust Y-pipe-to-RH catalytic converter nuts, and the Y-pipe.
-
Discard the nuts and gaskets.
-
To install, tighten to 40 Nm (30 lb-ft).
4. To install, reverse the removal procedure.
-
Install new gaskets and nuts.
5. Start the engine and check for exhaust leaks.
