Taurus AWD V6-3.5L (2009)
11. Remove the 2 floorpan bracket nuts.
-
To install, tighten to 3 Nm (27 lb-in).
Vehicles with power liftgate
12. Disconnect the power Liftgate/Trunk Module (LTM) electrical connector.
13. Remove the LTM bolt.
-
To install, tighten to 9 Nm (80 lb-in).
14. Remove the LTM and bracket.
All vehicles
15. Remove the 2 auxiliary duct pin-type retainers and detach the auxiliary ducts.
16. Disconnect the 2 auxiliary climate control housing electrical connectors.
17. Detach the auxiliary blower motor relay pin-type retainer(s).
18. Remove the 3 auxiliary climate control housing bolts.
-
To install, tighten to 6 Nm (53 lb-in).
19. Remove the auxiliary climate control housing.
20. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Add the correct amount of clean PAG oil to the refrigerant system.
21. Fill the engine coolant.
22. Evacuate, leak test and charge the refrigerant system.
