Taurus AWD V6-3.5L (2009)
4. Remove the receiver/drier outlet fitting bolt and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
5. Remove the 2 receiver/drier bolts.
-
To install, tighten to 9 Nm (80 lb-in).
6. Remove the receiver/drier.
7. To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Add the correct amount of clean PAG oil to the refrigerant system.
8. Evacuate, leak test and charge the refrigerant system.
