Taurus AWD V6-3.5L (2009)
Engine Control Module: Removal and Replacement
Powertrain Control Module (PCM)
Removal
1. NOTE: PCM installation DOES NOT require new keys or programming of keys.
Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure.
See: Information Bus/Testing and Inspection/Programming and Relearning
2. Remove the cowl panel grille.
3. Disconnect the 3 PCM electrical connectors.
4. Remove the 2 nuts and the PCM.
Installation
1. Install the PCM and the 2 nuts.
-
Tighten to 8 Nm (71 lb-in).
2. Connect the 3 PCM electrical connectors.
3. Install the cowl panel grille.
4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure.
See: Information Bus/Testing and Inspection/Programming and Relearning
5. Reprogram the Passive Anti-Theft System (PATS). Carry out the Parameter Reset procedure. See: Accessories and Optional Equipment/Antitheft
and Alarm Systems/Testing and Inspection/Programming and Relearning/Passive Anti-Theft System (PATS) Parameter Reset