Taurus AWD V6-3.5L (2009)
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 46 (7.5A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test F. See: Pinpoint Test F: The Occupant Classification System Module (OCSM) Does Not
Communicate With The Scan Tool
No
GO to R13.
-------------------------------------------------
R13 VERIFY VEHICLE EQUIPMENT - ACCESSORY PROTOCOL INTERFACE MODULE (APIM)
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Inspect the vehicle for an APIM.
-
Is the vehicle equipped with an APIM?
Yes
GO to R14.
No
INSTALL the removed fuse. An intermittent fault is not present. Go To Pinpoint Test S. See: Pinpoint Test S: No High Speed Controller Area Network
(HS-CAN) Communication, All Modules Are Not Responding
-------------------------------------------------
R14 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 3 (15A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test O. See: Pinpoint Test O: The Accessory Protocol Interface Module (APIM) Does Not Respond To
The Scan Tool
No
INSTALL the removed fuse. An intermittent fault is not present. Go To Pinpoint Test S. See: Pinpoint Test S: No High Speed Controller Area Network
(HS-CAN) Communication, All Modules Are Not Responding
-------------------------------------------------
Pinpoint Test S: No High Speed Controller Area Network (HS-CAN) Communication, All Modules
Are Not Responding
Communications Network
Pinpoint Tests
