Taurus AWD V6-3.5L (2009)
1. With vehicle in NEUTRAL, position it on a hoist.
2. Release the fuel system pressure.
3. Disconnect the battery ground cable.
4. NOTE: Some residual fuel may remain in the fuel tubes after releasing the fuel system pressure. When disconnecting or removing any fuel tubes,
carefully drain any residual fuel into a suitable container.
Disconnect the fuel supply tube-to-fuel rail jumper tube quick connect coupling.
5. Disconnect the fuel vapor tube-to-Evaporative Emission (EVAP) canister purge valve quick connect coupling.
6. Remove the bolt and release the fuel tubes from the bundle retainer.
-
To install, tighten to 20 Nm (177 lb-in).
7. Disconnect the fuel tube-to-fuel jumper tube quick connect coupling.
8. Remove and discard the EVAP canister rivet.
9. Remove the nut and position the fuel tube bundle shield and the EVAP canister shield aside.
-
To install, tighten to 9 Nm (80 lb-in).
10. Release the fuel tubes from the fuel tube bundle shield and remove the tubes.
11. To install, reverse the removal procedure.
