Taurus AWD V6-3.5L (2009)
Carry out the OCS system reset. If the system reset was successful, proceed to Step 25, otherwise proceed to Step 22.
22. If the first system reset attempt was unsuccessful, carry out a thorough visual inspection of the following:
-
OCS system wiring
-
Check the pressure sensor hose for kinks and/or damage
-
Related seat wiring harness, body wiring harness terminals and connectors
23. If the damage is found, repair and/or install new components as necessary.
24. Carry out a second OCS system reset. If the second attempt is unsuccessful, install a new OCS system service kit.
25. Prove out the SRS as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag warning indicator with the
air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an air bag SRS
fault is present, the air bag warning indicator will:
-
fail to light.
-
remain lit continuously.
-
flash.
The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the
time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault exists, a chime will
sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be diagnosed and repaired.
Clear all continuous DTCs from the RCM and OCSM using a scan tool.
