Taurus AWD V6-3.5L (2009)
-
Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)
If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing portion, a new
safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its
original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and
attaching hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard
passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the
risk of serious personal injury or death in a crash.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the upper and lower B-pillar trim panels.
2. Remove the secondary safety belt guide from the B-pillar.
3. Remove the D-ring bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
4. Position aside the scuff plate trim panel and remove the safety belt retractor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
5. Remove the safety belt retractor.
-
Unhook the safety belt retractor.
-
Disconnect the safety belt retractor electrical connector.
6. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
7. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety
Belt System See: Testing and Inspection/Component Tests and General Diagnostics.
