Taurus AWD V6-35L (2009) - Front Door Window Motor Exploded View
7. Disconnect the window motor electrical connector, then position the wiring harness aside.
-
Disconnect the 4 wiring harness retainers and the grommet.
-
Push the grommet through the opening and into the door panel.
8. Remove the interior door handle bolt, and position the door handle aside.
-
To install, tighten to 7 Nm (62 lb-in).
9. NOTE: If the window regulator motor is inoperative, remove it. For additional information, refer to Window Regulator Motor See: Window
Regulator Motor.
Lower the window until the glass clamp bolts can be accessed through the rear access hole and front door speaker opening.
10. Loosen the B-pillar front door window glass clamp bolt.
-
To install, tighten to 8 Nm (71 lb-in).
11. Loosen the A-pillar front door window glass clamp bolt.
-
To install, tighten to 8 Nm (71 lb-in).