Taurus FWD V6-3.5L (2008)
9. NOTE: Use either a high-ratio, electric or battery-operated caulk gun that will apply the urethane with less effort and continuous bead.
Apply urethane adhesive on top of the existing trimmed urethane adhesive bead on the pinch weld. Make sure that all gaps in the urethane
adhesive are smoothed into one continuous bead starting and ending at the bottom of the liftgate window glass opening near the center.
10. NOTE: Before the urethane has set, partially lower the windows to prevent the glass from being pushed out of position when a door is closed.
Install the liftgate window glass on the vehicle aligning it with the markings made previously.
11. WARNING: Do not drive vehicle until the urethane seal has cured. Follow urethane manufacturer's curing directions. Inadequate or
incorrect curing of the urethane seal will adversely affect glass retention. Failure to follow these instructions may result in serious injury
to vehicle occupant(s).
After the urethane has cured, check the liftgate window glass seal for air or water leaks through the urethane adhesive bead and add urethane
adhesive as necessary.
12. Install the liftgate trim panel.
