Taurus FWD V6-3.5L (2008)
personal injury or death in a crash.
-
If the seat side air bag cover has been damaged or separated from its mounting, or if the air bag material has been exposed, install a new seat
side air bag module. Never try to repair the seat side air bag module. Failure to follow these instructions may result in the seat side air bag
deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
CAUTION: Make sure the side air bag module wiring harness is not pinched between the side air bag module and the backrest frame.
Failure to follow this instruction may result in component damage and/or system failure.
Position the side air bag module studs through the backrest frame and install the nuts.
-
Tighten to 10 Nm (89 lb-in).
7. Route the side air bag module harness down the side of the backrest frame and install the pin-type retainers.
8. Position the backrest foam pad to the backrest frame.
9. NOTE: Vehicle with manual lumbar adjust shown.
Install the hog rings attaching the lumbar basket (if equipped) or backrest support (if equipped) and backrest foam pad to the backrest frame.
10. Position the backrest trim cover to the backrest foam pad and frame.
11. Roll the backrest trim cover down, attaching the hook-and-loop strips at the front and install the hog rings at the back.
