Taurus FWD V6-3.5L (2008)
Disc Brake System - Exploded View (Part 2)
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
CAUTION: Do not allow the brake fluid to come in contact with the adhesive backing on the brake pads. This may prevent the brake pad
adhesive surface from bonding with the brake caliper. If brake fluid is spilled onto the brake pads new pads must be installed.
CAUTION: Use only specified brake parts cleaner. Use of other cleaners may leave a residue on the brake caliper preventing the brake pads
adhesive surface from bonding with the brake caliper.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: New brake flexible hoses are supplied with new calipers. The brake flexible hose can be installed separately from the brake caliper.
Disconnect the brake tube fitting from the brake flexible hose.
^
To install, tighten to 17 Nm (13 lb-ft).
3. Remove the retaining clip from the brake flexible hose.
4. Disconnect the brake flexible hose from the brake caliper.
^
To install, tighten to 25 Nm (18 lb-ft).
5. To install, reverse the removal procedure.
^
Bleed the system.
