ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 8187 > < Initial Inspection and Diagnostic Overview
Page 2
background image

inoperative.

If the rear stoplamps are combined with the turn lamps, the turn and hazard lamp functions override the rear stoplamp function.

Field-Effect Transistor (FET) Protection

The SJB utilizes a FET protective circuit strategy for many of its outputs (for example, the headlamp output circuit). Output loads (current level) are
monitored for excessive current (typically short circuits) and are shut down (turns off the voltage or ground provided by the module) when a fault is
detected. A continuous DTC is stored at that time of the fault. The circuit then resets after a customer demand of the function (switching the
component on, battery saver being energized). When an excessive circuit load occurs several times, the module shuts down the output until a repair
procedure is carried out. At the same time, the continuous DTC that was stored on the first failure cannot be cleared by a command to clear the
continuous DTCs. The module does not allow this code to be cleared or the circuit restored to normal operation until a successful on-demand self-test
proves that the fault has been repaired. After the on-demand self-test has successfully completed (no on-demand DTCs present), the continuous DTC
clears and the circuit function returns.

Each circuit has three predefined levels of short circuit tolerance established in the module based on each circuits' capability. When the first or second
level is reached, the continuous DTC associated with the circuit sets along with DTC B106E. These DTCs may be cleared using the Clear DTC
operation on the scan tool as long as the fault itself has been corrected. If any of the circuits are shorted past the third level, then B106F sets along
with the associated continuous DTC. This DTC cannot be cleared and the module must be replaced.

The SJB FET protected output circuits for the stoplamp system are for the LH rear stop/turn lamp output and the RH rear stop/turn lamp output
circuits for Taurus and Taurus X. Sable does not have FET protected circuitry for the stoplamps.

Initial Inspection and Diagnostic Overview|Page 8187 > < Initial Inspection and Diagnostic Overview