Taurus FWD V6-3.5L (2008)
instructions may result in the safety canopy or side air curtain deploying incorrectly, which increases the risk of serious personal injury or
death in a crash.
-
Never put any type of fastener or tie strap around any part of a safety canopy module, side air curtain module or interior trim panel. This will
prevent the safety canopy or side air curtain module from deploying correctly. Failure to follow this instruction may increase the risk of serious
personal injury or death in a crash.
Position safety canopy module in vehicle.
-
Route the safety canopy module back through the rear window defroster wiring harness.
3. NOTE: Make sure all safety canopy module bolt holes line up with all J-clips.
Connect the safety canopy module electrical connector and install the 2 safety canopy module rear bracket bolts.
-
Tighten to 7 Nm (62 lb-in).
4. Install the safety canopy module 4 middle bolts.
-
Tighten to 7 Nm (62 lb-in).
5. Install the safety canopy module bolt, pin-type retainer to the A-pillar trim bracket and safety canopy module front tether bracket bolt.
-
Tighten the safety canopy module bolt to 7 Nm (62 lb-in).
-
Tighten the front tether bracket bolt to 9 Nm (80 lb-in).
Vehicles with moonroof
6. Attach the 2 front moonroof drain hose routing clips to the A-pillar.
